Skip to content

Cart

Your cart is empty

Hold Fast Rigging System

Hold Fast OG.

Quick safety reference and setup guide for the Hold Fast OG. Always inspect before use.

⚠ Inspect before every use
Bollard WLL2,000lbs · lowering
Winch WLL950lbs · lifting
Bollard rope9/16"max diameter
Winch rope1/2"max diameter
!
Not for human life support

For controlled lifting and lowering of materials only. Never lift, lower or support a person. This device is not PPE.

This page is a quick reference only. It does not replace formal training, industry standards or professional judgment. For use only by trained operators following accepted rigging practices.

Before first use

Watch setup. Read the manual.

Watch the videos and read the manual before your first rig.

1 · Mount itStep-by-step mounting walkthrough
2 · Lift & lowerHow to lift and lower with the winch and bollard
Every job. Every time.

Inspect before every use.

Watch the daily inspection tip, then tap each item as you clear it.

Daily rig inspectionTip: tighten your winch drum before you lift

Pre-use check

0 of 5 cleared
Remove from service immediately if any component shows signs of damage, excessive wear or deformation.

Rig it safe

  • Never exceed rated working load limits.
  • Avoid shock loading and side loading.
  • No wire rope. No chain.
  • The lowest-rated part of the rig sets the limit for the whole system.
  • Use in accordance with ANSI Z133 and OSHA 1910.269 / 268.

Maintenance & storage

  • Clean after use.
  • Store dry.
  • Tighten the winch drum before lifting, if needed. Watch the tip ↑
  • Remove from service if damaged.
Need help?

Questions, parts or inspection concerns?

Email Hold Fast Rigging and we'll get you sorted.

Email Hold Fast Support
Rig safe. Hold Fast.Manufactured by Hold Fast Rigging · Indiana, USA